Accessory
You may find these products in the shop by "Parts & Accessory" and further information below:
Zylinder
The cylindrical rubbers are put on the piston rod.
Depending on the quantity and height, different spring travel limitations result.
PUR
These PUR bump stops are to be used instead of the original limiters and are put on the piston rod.
Anti Dust Cover
Is placed over the piston rod to prevent dirt accumulation.
Suitable for all LOWTEC and COMP Coilovers.
Special Aluminium Strut Bearing
The LOWTEC aluminium strut bearings are constructed so that maximum lowering can be achived through minimal construction height. Contrary to other products with problematic and noisy pillow ball-bearings, the LOWTEC aluminium strut bearing kit will damp the piston rod by a special rubber bearing. So fully mobility of the strut at each steering angle is given. An optimized axial bearing ant ehe upper spring up is included.
The stadard version retains the OE camber, while the -0,5° version results a fixed neagtive camber.
The strut bearings are suitable for all LOWTEC coilovers and coilovers of other manufacturers with upper springs with an outer diameter of max. 85mm and piston pin with the dimension M14 x ca. 40mm length. Adjustment are optionally available upon request.Did you find the information you were looking for?